Paragliders are unique among human-carrying
aircraft in being easily portable. The complete equipment packs into a rucksack
and can be carried easily on the pilot's back, in a car, or on public
transport.[14] In comparison with other air sports, this substantially
simplifies travel to a suitable takeoff spot, the selection of a landing place
and return travel.
Tandem paragliders, designed to carry the
pilot and one passenger, are larger but otherwise similar. They usually fly
faster with higher trim speeds, are more resistant to collapse, and have a
slightly higher sink rate compared to solo paragliders.
连云港小型滑翔伞源头直供厂家
每条线的顶部连接到缝在机翼结构中的小织物线圈上,这些织物线圈通常成行排列(即,左右)。**靠近前一行的行称为A线,下一行称为B线,依此类推。典型的机翼将具有A,B,C和D线,但是**近,有一种趋势是将行的行数减少到三行,甚至两行(并从实验上减少到一行),以减少阻力。
滑翔伞线通常由迪尼玛/光谱或凯夫拉尔/芳纶制成。尽管它们看起来很苗条,但这些材料非常坚固。例如,一条直径为0.66毫的线(大约**细)可以具有56千克的断裂强度。
滑翔伞的滑翔率范围从休闲机翼的9.3到现代竞赛模型的约11.3,在某些情况下高达13。为了进行比较,典型的跳伞降落伞将实现约3:1的滑行。悬挂式滑翔机的范围从休闲机翼的9.5到现代竞赛机型的约16.5。空转(滑行)的塞斯纳152轻型飞机将达到9:1。一些滑翔机可以实现高达72:1的滑行比。
滑翔伞的速度范围通常为每小时20-75公里(12-47英里/小时),从失速速度到比较大速度。初学者机翼将位于该范围的下部,高性能机翼将位于该范围的上部。
为了存放和携带,机翼通常被折叠成一个行李袋,然后可以与安全带一起存放在一个大背包中。对于可能不希望增加背包重量或烦恼的飞行员,一些现代安全带具有将安全带内翻的功能,从而使其成为背包。
虹口区官方滑翔伞哪家好
显示滑翔伞各部分的横截面:
1)上表面
2)下表面
3)肋骨
4)对角肋
5)上线级联
6)中线串级
7)下线级联
8)立管
滑翔伞的机翼或机盖通常在工程上称为“冲压空气翼型”。这样的翼包括两层织物,它们以形成一排网孔的方式连接到内部支撑材料上。通过使大多数舱室*在前缘处敞开,进入的空气使机翼保持充气状态,从而保持其形状。充气时,机翼的横截面具有典型的泪滴翼型形状。现代滑翔伞的机翼是由高性能的无孔材料制成的,例如尼龙纤维。
在某些现代滑翔伞(从1990年开始中,尤其是性能更高的机翼中,前缘的某些舱室被封闭以形成更干净的空气动力学轮廓。内部肋骨上的孔允许空气从开孔到这些闭孔的自由流动,以使它们膨胀,并向也闭合的翼尖膨胀。
飞行员通过悬吊线网络支撑在机翼下方。这些从两根短的(40厘米)长的坚固织带制成的立管开始。每组由一个登山扣固定在吊带上,飞行员的每一侧上各有一个,每个组的立管通常*从机翼一侧的一行上连接到绳索上。在该组的每个立管的末端,都有一个小三角洲的马龙,上面挂有数行(2 – 5)条线,形成一个风扇。这些线通常长4 – 5米,末端连接到大约2 m的另外2 – 4条线上,这些线又连接到一组更细的细线上。在某些情况下,对第四级联重复此操作。
滑翔伞在“大耳朵”机动
在不加速的情况下,正常飞行会拉动外部A线,使翼尖向内折叠,这将大大减小滑行角,而前进速度*会小幅下降。随着有效机翼面积的减小,机翼载荷增加,并且变得更加稳定。但是,迎角增加了,飞行器更接近失速速度,但是可以通过应用速度杆来改善,这也增加了下降速度。释放管路时,机翼会重新膨胀。如有必要,在制动器上短暂抽气有助于重新进入正常飞行。与其他技术相比,机翼大了,机翼仍然向前滑动,这使飞行员可以离开危险区域。例如,如果飞行员必须抵抗斜坡上的上升气流,这种方式甚至可以降落。
B线失速
在B线停转中,从前缘/前端起的第二组立管(B线)**于其他立管被下拉,其中特定的线用于启动停转。这在翼上产生翼展方向的折痕,从而使气流与翼的上表面分离。它显着降低了顶篷产生的升力,从而导致更高的下降率。这可能是费力的动作,因为必须将这些B线保持在该位置,并且机翼的张力会在这些线上施加向上的力。必须小心处理这些线的释放,以免引起机翼向前飞快射击,然后飞行员可能掉入其中。现在这已经不那么流行了,因为它在机翼的内部结构上引起了高负荷。
The next step in the launch is to bring the
wing into the lift zone. There are two techniques for accomplishing this
depending on wind conditions. In light wind this is usually done after turning
to the front, steering with the feet towards the low wing tip, and applying
light brakes in a natural sense to keep the wing horizontal. In stronger wind
conditions it is often found to be easier to remain facing downwind while
moving slowly and steadily backwards into the wind.
Knees bent to load the wing, foot
adjustments to remain central and minimum use of Cs or Brakes to keep the wing
horizontal. Pirouette when the feet are close to lifting. This option has two
distinct advantages. a) The pilot can see the wing centre marker (an aid to
centring the feet) and, if necessary, b) the pilot can move briskly towards the
wing to assist with an emergency deflation.
With either method it is essential to check
"traffic" across the launch face before committing to flight.
虹口区官方滑翔伞哪家好
连云港小型滑翔伞源头直供厂家
Forward launch
In low winds, the wing is inflated with a
forward launch, where the pilot runs forward with the wing behind so that the
air pressure generated by the forward movement inflates the wing.
It is often easier, because the pilot only
has to run forward, but the pilot cannot see his wing until it is above him,
where he has to check it in a very short time for correct inflation and
untangled lines before the launch.
Reverse launch
File:Paraglider launch Mam T
Paraglider reverse launch, Mam Tor, England
In higher winds, a reverse launch is used,
with the pilot facing the wing to bring it up into a flying position, then
turning around under the wing and running to complete the launch.
连云港小型滑翔伞源头直供厂家
上海翼舞航空科技有限公司创立于2017-03-08,是一家生产型公司。翼舞致力于为客户提供质量的[ "动力伞", "滑翔伞", "飞行", "热汽球" ],一切以用户需求为中心,深受广大客户的欢迎。公司秉持诚信为本的经营理念,在运动、休闲深耕多年,以技术为先导,以自主产品为**,发挥人才优势,打造运动、休闲质量品牌。在社会各界的鼎力支持下,经过公司所有人员的努力,公司自2017-03-08成立以来,年营业额达到10万元以下。